Why is My Dishwasher Leaking?

Getting up in the morning only to step in a large puddle on the floor is no-one’s chosen way to start the day.

Luckily, most commonplace sources of dishwasher faults are comparably easy to determine and mend by yourself. Meaning you may not have to hand wash the dishes for too long, take a day off waiting for an engineer or have to pay the call-out fee.

So, if you’re feeling up to it get out the instruction manual if you can, clean up the mess and so get something clean up any additional spills and so see if you can’t fix the problem. If you aren’t able to call us for local dishwasher repair.

Everyday Explanations of Dishwasher Faults and How to Mend Them

Many of the most everyday sources of dishwasher faults are not actually a result of a dishwasher issue at all. Prior to starting preparing yourself for an engineering task and flicking through numerous youtube tutorials there are a few issues you might want to rule out first.

  1. Check to see if your dishwasher is aligned. If your dishwasher isn’t aligned water will easily pool as well as spill out even if the dishwasher is working perfectly.
  2. Test you have been using the correct soap. You may be familiar with this problem with your washing machine. An excess of soap or using the incorrect type can lead to too many suds, the bubbles spill over resulting in a spill.
  3. Test your dishwasher door closes fully. If it doesn’t you might have an object blocking it such as a large plate, or you could have to adjust the hinge or the locking mechanism.
  4. Check the filter located at the base of the tub for any easy to see drainage issues as if your dishwasher isn’t draining effectively this will cause it to fill too much and leak.

If you have ruled out these issues it’s time to get ready and start the investigation.

The easiest place to start is the door and test for any visible issues in the interior of the machine before you move on to the underside. If you are able to identify and so fix the leak before you have to pull out the dishwasher you’ll save yourself a lot of hassle.

Before you do anything else make sure you disconnect the appliance.

Door Gasket

The most everyday place for leakage is around the door, fortunately it is likewise one of the easiest problems to fix.

If the leakage is periodic the problem might be as straightforward as a large plate or something else putting pressure into the door thus stopping it from closing properly.

On the other hand the door seal could have come loose or become cracked.

Inspect the door seal and also check for any brittleness, mineral deposits or other gunk, or any parts in which the seal has come away from the door.

Taking off the gasket and also allowing it a good scrub might improve the situation in some cases or you might need to acquire a new seal and change it.

Water Inlet Valve (Solenoid Fill Valve)

The fill valve can be a further everyday problem. The inlet is generally found under the machine which means you may have to unscrew the toe board and could need to remove the door cover.

The water inlet valve opens and also closes to allow water into the tub at different parts of the programme. The inlet valve could be damaged, demonstrated by a slight drip, or it may be damaged and not operating correctly while the dishwasher is running.

In the case that the water inlet valve doesn’t close fully this can result in the dishwasher leaking.

Usually these valves can’t be repaired, which means the entire valve would have to be replaced.

Leaking Hoses

Hoses are needed to fill, empty as well as recirculate water along the programme.

Two complications could arise when it comes to hoses.

  1. The gaskets may break or the contact points may work loose thus it’s worth having a look at all the connection points first.
  2. The alternative problem than might often develop as time goes by is that hoses might be damaged or get a hole in.

If you are able to see that the leak is a result of a faulty hose this should be relatively easy to replace and replacement hoses are readily available.

Pumps and Seals

You are able to visually investigate the seals that are part of the pumps or motor to determine if there is a leakage and also change them if that’s the case.

The Float Switch

The float itself or the float switch may be damaged resulting in the dishwasher overfilling.

When operating as it should the float will lift up as the water level goes up until the desired or maximum water level is reached. The end piece of the float will then operate the switch. If something is blocking this or the float is broken this could be causing your issues.

Testing the switch will require a multi-meter although it could be noticeably broken in which case getting a new one should resolve the problem.

Alternative Components that May Lead to a Leak

A cracked wash arm or support could resulting in a leak. This can likewise often affect how well your dishes are being cleaned.

Broken or faulty lines can likewise cause this issue as may a broken pump cover if your dishwasher has one.

The motor shaft gasket might have come loose causing a leak. This generally presents as leakage coming from the underside of the machine.

Top Tips to Fix Your Dishwasher

  1. Save money by replacing the gasket instead of the whole component. In many instances, you can purchase the gasket separately which saves time as well as money.
  2. Check the simple resolutions first. There’s no point pulling the entire machine away from the wall if it’s the soap that’s making the problem.
  3. Take pictures at each step. This may help you reverse the process, explain the component you are looking for to a sales person, and explain the issue to a repair person if required.
  4. Be careful. Water and electricity do not mix so turn off the power first.
  5. If in doubt get in a professional.

The Next Steps You Should Take If Your Initial Investigation Fails to Identify or Resolve the Leakage

If the cause of the problem is still a mystery the thing you may do is to pull the machine away from the wall to get a better look underneath it and add water to the tub to see whether the leak presents itself.

If you don’t find any leakages with this method your dishwasher may only leak if during a cycle. If this is the case, you may wish to hire a appliance repair person to determine as well as fix the leak as there are safety risks of checking for faults with electrical parts uncovered.

More Dishwasher Problems: